Video Output - Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento

Command
Signal present:
Timecode present:
Closed captioning present:
Wide SD aspect:
Optical module present:
Video pixel format:

Video Output

Command
Video mode:
Aspect ratio:
Video demux mode:
Output SDI mode:
Video pixel format:
Analog output:
HDMI Output:
Output option:
Quad ancillary replication:
Quad SDI output:
Command Description
True indicates presence of input video.
False indicates no input video is present.
Cannot be changed by the user.
Detected indicates presence of timecode.
None indicates no timecode is present.
Cannot be changed by the user.
Detected indicates presence of closed captions.
None indicates no closed captions are present.
Cannot be changed by the user.
Values are: True or False. False indicates the SD source is 4:3. True
indicates the SD source is widescreen and should be displayed in
an SD output in a Letterbox mode.
Indicates the presence of an installed fiber optic SFP module.
True=Installed; False=Not installed
Displays input pixel format, e.g. YCrCb422.
Cannot be changed by the user.
Command Description
The Video Mode may be set to any available output video format.
Refer to the format conversion table for output formats available in
your Teranex. For example, 2160p59.94.
The Aspect Ratio value may be set to an aspect ratio appropriate for
the current conversion. Values are based
on availability in the device and the current conversion: Anamorphic,
Letterbox, CentreCut, 14x9, Smart.
The Video demux mode applies to the Teranex 3D and Teranex
Express. Values are: SingleLink, DualLink, QuadLink. This command
corresponds with the 'SDI Output' LCD menu.
For Teranex AV and Teranex Express only, select the 3G-SDI output
type. Values are LevelA, LevelB. This command corresponds with
the '3G-SDI Output' LCD menu.
The Video pixel format applies to the Teranex 3D only. Values are:
YCbCr422, RGB422, RGB444.
Select the analog video output type.
Values are: Composite, Component
For Teranex AV only. Select the color space for the HDMI output.
Values are: YCbCR422, RGB444
For Teranex AV only. Select one of four signals to be used as the
output of the unit. Values are: Input, Black, Still, Freeze. The
"Transition setting" command controls the transition rate.
For Teranex AV and Express. True = replicate the ancillary data on
all four quad link outputs. False = ancillary data on quad output A
only.
For Teranex AV only. Select the quad SDI output mode. Values are:
QuadLink, QuadHDSplit.
Informations pour les développeurs 359 359