System Setup Menu Settings - Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento

System Setup Menu Settings

The 'system setup' menu provides access to the 'ethernet,' 'factory reset' and 'reference'
menus, as well as a system 'info' screen. Teranex AV offers additional selections, including
processing latency and still frame capture controls.
Ethernet Menu
The 'Ethernet' menu allows you to display the current settings and assign new settings for static
'IP' address, 'subnet mask' address and IP 'gateway'. This menu also permits you to turn DHCP
'on' or 'off'.
When DHCP is 'on', the IP, 'subnet mask' and 'gateway' menus will display the addresses
currently assigned to the chassis by the DHCP server. These values may not be adjusted unless
DHCP is 'off'.
IP Menu
To set a static IP address for the Teranex processor, DHCP must be 'off'.
The IP menu will display a four-field register allowing you to enter specific IP address values.
Adjust the selection highlighted by the cursor by turning the rotary knob. Use the 'prev' and
'next' buttons to move the cursor to the left or right, respectively. If you change this setting,
press the 'back' button, then press the 'save and restart' button to power cycle the chassis and
establish the new setting.
Video Main Menu
Audio
Noise
Reduction
Ancillary
Data
Main Menu>System Setup
Subnet Mask Menu
The 'subnet mask' menu will display a four-field register allowing you to enter specific values.
Adjust the selection highlighted by the cursor by turning the rotary knob. Use the 'prev' and
'next' buttons to move the cursor left or right, respectively. If you change this setting, press the
'back' button, then press the 'save and restart' button to power cycle the chassis and establish
the new setting.
Prev Ethernet
n
IP
225:255:255:0
Subnet
Mask
Save and
Restart
System Setup Menu>
Ethernet>Subset Mask
Gateway Menu
The 'gateway' menu will display a four-field register allowing you to enter specific values.
Adjust the selection highlighted by the cursor by turning the rotary knob. Use the 'prev' and
'next' buttons to move the cursor left or right. To establish new settings, press the 'back' button,
then 'save and restart'. Your Teranex will power cycle and apply the new settings.
System
Ethernet System Setup
Setup
System Setup Menu>Ethernet
Next Prev Ethernet
n
Getaway IP
190:169:10:1
Subnet
DHCP
Mask
Save and
Restart
System Setup Menu>
Ethernet>Gateway
Factory
Prev Ethernet
Reset
Reference n
IP 192:126:10:50
Subnet
Info
Mask
Save and
Restart
System Setup Menu>Ethernet>IP
Next Prev Ethernet
On
Getaway IP
Off
Subnet
DHCP
Mask
Save and
Restart
System Setup Menu>
Ethernet>DHCP
Teranex Processor Settings
Next
Getaway
DHCP
Next
Getaway
DHCP
60 60