Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento página 76

Connections and Other Important Information for 3D Modes
Let's detail some of the connections and ancillary data handling that will affect your workflows.
Video Connections
Stereoscopic left and right video inputs should be connected to SDI inputs A and B
respectively. Similarly, left and right processed outputs will be available at SDI outputs A and B
respectively. The HDMI input and output connections support full frame 'frame packed' signals.
Video Formats Supported
The 2D to 3D feature supports SD and HD inputs, and converts to an HD output. The '3D
convert' and '3D camera align' features support all 3D-centric video formats that are supported
by the Teranex 3D. For '3D align', both input streams, left and right, must be of the same format
and frame rate. The following video format conversions are supported:
‚ Input and output video signals up to 1.5Gb/s.
‚ Pass-through, where the output format is the same as the input format.
‚ 1080i 50/59.94/60 to 1080p/PsF 23.98/24/25/29.97/30
‚ 1080p/PsF 23.98/24/25/29.97/30 to 1080i 50/59.94/60
‚ 1080i 50/59.94/60 to 1080i 50/59.94/60 Frame Rate Conversion
‚ 1080i 50/59.94/60 to 720p 50/59.94/60
‚ 720p 50/59.94/60 to 1080i 50/59.94/60
‚ 720p 50/59.94/60 to 720p 50/59.94/60 Frame Rate Conversion
Independent Channel Processing
Image alignment for each video channel is possible via the 'camera align' application. Proc amp,
timecode and noise reduction settings are applied simultaneously to both video streams.
Audio Support
Embedded, AES and Analog audio is supported for 'channel A'. When selecting 'embed', the
embedded audio on input A will be processed and outputted via output A.
Ancillary Data Support
Ancillary data such as timecode and AFD is supported on input A and output A only.
External Reference
The output streams may be synchronized to either Input A or to an external reference of black
burst or Tri-level sync supplied to the REF connector. Select the type of reference, internal or
external, using Home>Reference>Type.
When using an external reference, the interface controls both channel A and B, enabling both
output streams to remain pixel locked, even when adjusted relative to the selected
reference source.
Teranex Processor Settings 76 76