Configuring Buzzer Out Settings - Lorex L23WD800 Serie Manual Del Usuario

Figure 25.4 Alarm output selection.

Configuring Buzzer Out Settings

To configure Buzzer Out settings:
1. Click the Buzzer Out sub-menu on the navigation bar on the left (Sensor>Buzzer Out). The
Buzzer Out Setting window opens.
Figure 25.5 Buzzer Out Settings window.
2. Under the Operation drop-down menu, select Enable configure buzzer settings.
3. Under the Mode drop-down menu, select Transparent or Latched.
4. Under the HDD Event drop-down menu, select ON to enable to trigger the buzzer when an
HDD event occurs.
5. For each channel, select which events you want to trigger the buzzer.
• For example, you may want a video loss and motion event in channel 2 to trigger a buzzer.
6. Click OK to save your settings.
Using Web Remote Viewer
In this example, Video Loss and
Motion is selected in channel 2.
If video loss or motion occurs in
channel 2, it triggers an alarm
output.
117