Camera; Camera Setup; Title; Covert - Lorex L23WD800 Serie Manual Del Usuario

Using the System Menu

CAMERA

Use the Camera menu to configure
camera, color, PTZ and motion
settings.

CAMERA SETUP

Use the Camera Setup menu to change
camera titles, enable/disable covert camera,
and configure audio
To configure Camera Setup options:
1. Click the SETUP button (
Status Bar.
2. Click SYSTEM SETUP.
3. Click CAMERA.
• The Camera setup window opens.
Figure 10.2 Camera Setup menu
If your system has 16 channels, click
NOTE:
PAGE UP/PAGE DOWN to change pages.

Title

To change a camera title:
1. Under TITLE, double-click a channel to
open the Virtual Keyboard.
2. Enter a title for the camera (up to eight
alphanumeric characters),and click OK.
• The Virtual Keyboard closes.
3. Click APPLY to save your settings or select
CANCEL to restore defaults.
4. Click CLOSE to exit the camera setup
window.
52

Covert

Covert allows you to blank out the channel(s)
when the system records. This allows you to
record discreetly when the system is in viewing
mode.
To enable/disable covert camera:
1. Under COVERT, select a channel and click
ON/OFF to enable/disable covert mode
ENTER.
• If ON, the channel will appear blacked out
on-screen, but the system will actually be
recording.
2. Select APPLY and press ENTER to save
) in the
your settings or select CANCEL to restore
defaults.
3. Select CLOSE and press ENTER to exit.

Audio

The system can record from up to four audio
channels. By default, channels 1~4 are
enabled for audio recording. Use the Camera
Setup menu to customize audio recording.
To enable/disable audio recording:
1. Under AUDIO, click a desired channel to
configure audio settings.
2. Select CH 1, CH 2, CH 3, CH 4, or OFF by
clicking
3. Click APPLY to save your settings or select
CANCEL to restore defaults.
4. Select CLOSE and press ENTER to exit.
NOTE:
If straying from the default configuration,
ensure that you assign the correct audio
channel to the corresponding camera
channel. For example, you want to connect
audio-capable cameras to channels 1, 2, 7
and 8: under AUDIO, you would select CH1
for camera 1, CH 2 for camera 2, CH 3 for
camera 7, and CH 4 for camera 8.
.
audio
CH 1~4 refer to channels 1~4.