Connecting Bnc Cameras; Connecting And Removing Bnc Cables - Lorex L23WD800 Serie Manual Del Usuario

CONNECTING BNC CAMERAS

To install BNC cameras to your system:
1. Connect the male power connector on the BNC extension cable to the female power
connector on the camera.
• Connect the BNC connector to the camera.
2. Connect the female power connector on the BNC extension cable to the power adapter.
• Connect the BNC connector to the BNC port on the system.
3. Plug the power adapter to a power outlet.
Male power connector
Figure 2.9 BNC camera connectivity diagram.

Connecting and Removing BNC cables

BNC (Bayonet Nut Connector) is a special connector that locks on to the system port, and cannot
be accidently removed.
To connect or remove a BNC connector:
• Push the BNC connector firmly into the BNC port and simultaneously twist the connector
clockwise to tighten.
• To remove a BNC connector from a BNC port, push and simultaneously twist the connector
counter-clockwise to loosen the BNC connector.
BNC Extension cable
Female power connector
13