Modifying An Existing Sequence; Deleting A Sequence; Spot Out - Lorex L23WD800 Serie Manual Del Usuario

Using the System Menu
2. Beside ACTIVATION, click
ON.
3. Select SAVE.
• The EDIT window closes.
4. Click APPLY to save your settings.

Modifying an Existing Sequence

To modify or edit an existing sequence:
1. Under LIST, double-click the desired
sequence to edit.
• The EDIT window opens.
2. Click MODIFY.
• The Add Sequence window opens.
3. Double-click the desired grid icon to edit.
• The Sequence Setup window opens.
4. Modify the sequence using VIEW TYPE and
CONFIGURE options.
5. Click CONFIRM to save your changes.
6. Click CLOSE to exit.
7. Click APPLY to save your settings or select
CANCEL to restore defaults.

Deleting a Sequence

To delete a sequence:
1. Under LIST, double-click the sequence you
wish to delete.
• The EDIT window opens.
2. Click DELETE.
• The EDIT window closes.
3. Click APPLY to save your settings or click
CANCEL to restore defaults.
58

SPOT OUT

to select
Use the Spot Out menu to customize the spot
outputs on the system. The system assigns a
single channel, full-screen sequence to each
spot output.
NOTE:
To edit a spot-out sequence:
1. Click the SPOT OUT tab on the left.
• The Spot Out window opens.
Figure 11.9 Spot Out menu.
2. Under LIST, double-click a Spot Out title.
• The Edit window opens.
Figure 11.10 Spot Out Edit window.
3. Double-click the field beside SPOT TITLE,
to open the Virtual Keyboard. Enter a name
for the Spot Out sequence.
4. Under ACTIVATION, click
ON/OFF to enable/disable the Spot Out
sequence.
5. Click MODIFY .
You can set up to 16 sequences.
to select