Appendix B: Replacing The Hard Drive - Lorex L23WD800 Serie Manual Del Usuario

APPENDIX B: REPLACING THE HARD DRIVE

The system comes with a pre-installed 3.5" SATA hard drive. Make sure that the system is
and the power cable has been disconnected before changing the hard drive.
NOTE: The factory hard drive is pre-installed with a demo video (accessed by holding the +10
button on the front panel). Once the factory hard drive is replaced, the demo video will not be
available.
Removing the Hard Drive
To remove the hard drive:
1. Remove the 4 (four) short black screws on the rear panel.
2. Carefully remove the bracket with the attached hard drive.
NOTE: The hard drive is attached to the bracket. Be careful not to tug or drop the hard drive.
SATA cables
Appendix B: Replacing the Hard Drive
OFF
143