Color Setup; Ptz Setup - Lorex L23WD800 Serie Manual Del Usuario

COLOR SETUP

Use the Color Setup menu to adjust
Brightness, Contrast, Tint, and Color for each
camera.
To configure color settings:
1. Click the COLOR SETUP tab on the left.
• The Color Setup window opens.
Figure 10.3 Color Setup menu
2. Double-click the desired value you wish to
adjust.
• The channel opens in full-screen with the
color options in a bar at the bottom of the
screen.
Color options bar
Figure 10.4 Adjusting color options.
3. Under BRIGHTNESS, CONTRAST, TINT,
and COLOR , click
values.
• To enter the values quickly, double-click
the individual values to open the number
window. Use the number window to enter
the desired value.
4. Under the Channel number, click
change the channel number. Apply color
settings as required.
5. Click the X on the top-right corner of the

PTZ SETUP

Use the PTZ Setup menu to configure any
connected PTZ (Pan, Tilt, Zoom) cameras (not
included).
To configure PTZ settings:
1. Click the PTZ SETUP tab on the left.
Figure 10.5 PTZ Setup menu.
2. Under ADDRESS, click
3. Under PROTOCOL, select Pelco-D, PelcoP
to adjust the
4. Under BAUD RATE, select 9600 (default),
5. Click DETAIL.
to
Using the System Menu
color options bar to exit.
Make sure your PTZ camera is
NOTE:
properly connected to the system prior to
configuring PTZ options. Please refer to
your PTZ camera's instruction manual to
determine the correct settings for your PTZ
camera.
• The PTZ Setup window opens.
PTZ address.
• OR, double-click on the value to open the
number window. Use the number window
to enter the desired PTZ address.
• PTZ address range: 1~255.
MESA-DOME, D-MAX, FastraxII 2, Ganz PT
V3 2, Scc641, Scc643a, Spd 3300, Multix,
MRX1000, WV-cs850, WV-csr604,
PTC-400c, PTC-200, TAKEX, LPT-A100L,
interM, VITEK, LILIN.
4800, 2400, 115200, 57600, 38400, or
19200.
to change the
53