Abs - APRILIA ETV mille Caponord 2003 Libro De Uso Y Mantenimiento

ETVmille_ABS_UK.book Page 35 Friday, October 24, 2003 12:25 PM
4 5 3
1 2

ABS

The ABS is a control system avoiding
wheels locking in case of emergency
braking and providing improved vehicle
stability during braking.
When brake is pulled, so during wheels
lock, tires slip on the road surface, thus
adversely affecting vehicle stability.
A position sensor (1) ≈reads∆ on phonic
wheel (2) √ integral with the vehicle wheel
√ the wheel status and wheel locking, if
any.
The signal is sent to a control unit (3) that
will adjust braking system pressure
accordingly.
NOTE
When the ABS is enabled, the
brake lever will vibrate.
All manuals and user guides at all-guides.com
6
1 2
The wheel anti-lock system does not
protect the rider from falling during
cornering. An emergency braking, i.e. with
vehicle leaned aside, handlebars turned,
on bumpy or slippery road surface or in
case of low adhesion, will lead to an
unstable condition, quite difficult to be
handled with by the rider. We thus strictly
recommend to ride safely, brake gradually
and remain alert at all times. Do not ride
fast in vain hope to be safe. When braking
while bending or turning, the motorcycle
is subject to physics laws even if equipped
with ABS.
When engine is started warning light (6)
remains on for about 3 seconds. If the
w a r n i n g l i g h t d o e s n o t g o o u t , a
malfunction is present and the ABS is then
disabled.
C o n s u l t a n A p r i l i a O f f i c i a l D e a l e r
immediately.
1
2
!
WARNING
1
Riding with the ABS on
Warning light (6) remains off.
In case of a malfunction, the warning light
w i l l r e m a i n o n . T h e A B S w i l l b e
automatically disabled.
C o n s u l t a n A p r i l i a O f f i c i a l D e a l e r
immediately.
Riding with the ABS off
Warning light (6) continues flashing.
Disabling the ABS
Press the switch (7) once the light has
turned off to disable the ABS, when the
engine is running and the motorcycle has
halted. The warning light will start flashing:
release switch before the fifth light flashing.
To re-enable the ABS, stop the bike, switch
the engine off and start it again.
use and maintenance ETV mille Caponord ABS
2
35