Recharging The Battery; Installing The Battery - APRILIA ETV mille Caponord 2003 Libro De Uso Y Mantenimiento

ETVmille_ABS_UK.book Page 96 Friday, October 24, 2003 12:25 PM

RECHARGING THE BATTERY

Carefully read p. 94 (BATTERY).
!
CAUTION
Do not remove the battery plugs:
without plugs the battery may be
damaged.
◆
Remove the battery,
(REMOVING THE BATTERY).
◆
Prepare an appropriate battery charger.
◆
Set the charger for the desired type of
recharge (see table).
◆
Connect the battery with a battery
charger.
!
WARNING
During the recharging or the use, make
sure that the room is properly ventilated
and avoid inhaling the gases released
during the recharging.
◆
Switch on the battery charger.
Electric
Recharge current
(Amperes)
Normal 1.2
Quick 12
!
WARNING
Reassemble the battery only 5/10
m i n u t e s a f t e r d i s c o n n e c t i n g t h e
recharge apparatus, since the battery
continues to produce gas for a short
lapse of time.
96 use and maintenance ETV mille Caponord ABS
All manuals and user guides at all-guides.com
see p. 95

INSTALLING THE BATTERY

Carefully read p. 94 (BATTERY).
◆
Make sure that the ignition switch is in
position ≈?∆.
◆
Remove
( U N L O C K I N G / L O C K I N G
PASSENGER SEAT).
NOTE
The
positioned in its compartment with the
Time
terminals directed towards the rear part of
(hours)
the vehicle.
◆
Put the battery (1) in its compartment.
8 √ 10
◆
Put back the bracket (2) that locks the
0.5
battery.
◆
Screw and tighten the screw (3).
the saddle, see p. 26
T H E
battery (1) must be
6 4
1
2
!
WARNING
Upon reassembly, connect first the
positive cable (+) and then the negative
cable (–).
◆
Connect the positive terminal (+) by
means of the screw (4).
◆
Connect the negative terminal (–) by
means of the screw (5).
◆
Put back the red protection element (6).
◆
Put back the saddle, see p. 26
( U N L O C K I N G / L O C K I N G
PASSENGER SEAT).
3
5
T H E