Changing The Headlight Bulbs - APRILIA ETV mille Caponord 2003 Libro De Uso Y Mantenimiento

ETVmille_ABS_UK.book Page 102 Friday, October 24, 2003 12:25 PM
2
1
6
4
CHANGING THE HEADLIGHT
BULBS
Carefully read p. 101 (BULBS).
The headlight contains:
√ two high beam bulbs/low beam (1)
(side);
√ one parking light bulb (2) (lower).
If one of the two low beam/high beam
bulbs is damaged and no spare bulb is
available, it is possible to invert them.
This operation is intended only to make it
easier for the rider to go back home or to
reach a shop where he can by a new bulb,
but the replacement of the damaged bulb
remains indispensable.
102 use and maintenance ETV mille Caponord ABS
All manuals and user guides at all-guides.com
1
1
3
HIGH BEAM BULBS/LOW BEAM
NOTE
Proceed on the side of the bulb to
be changed.
NOTE
Extract the connectors one by
one, in such a way as to avoid positioning
them wrongly upon reassembly.
If it is necess ar y to remove all the
connectors at the same time, mark them
and make sure that you position them
correctly upon reassembly.
!
To extract the bulb electric connector,
do not pull its electric wires.
◆
Grasp the electric connector (3) of the
b u l b t o b e r e p l a c e d , p u l l i t a n d
disconnect it from the bulb (1).
◆
Move the protection element (4) of the
bulb to be changed with your hands.
5
CAUTION
5
◆
Release the two ends of the check
spring (5) positioned on the bulb socket
(6).
◆
Extract the bulb from its seat.
NOTE
Insert the bulb in the bulb socket,
making the respective positioning seats (A)
coincide.
◆
Correctly install a new bulb of the same
type.
Upon reassembly:
NOTE
Put back the protection element
(4) with the tang (6) facing upwards.
A