Publicidad
Idiomas disponibles
Idiomas disponibles
To end an oximetry test press the power ON/OFF key. If the ESC icon is touched
the image to the right will be displayed for a few seconds
2.14.1
Walk test (6MWT)
To access the oximetry area touch the
The walk test is comprised of three stages:
•
Initial rest
•
walking
•
recovery
WARNING
During testing proper step-counter reading is obtained by positioning the device on
the chest as shown in the image on the right side.
The holder is optional and is provided only if requested.
Initial rest stage
In this stage the display will show the following data:
•
Test time duration
•
Signal quality indication
•
Current stage
•
SPO2 percentage value and the cardiac pulse rate(BPM) (heart symbol)
The "initial rest" stage must continue for a minimum of 2 minutes, after which the
icon to move on the next "walking" stage. If the user does not move on to the "walking" stage, a few seconds before reaching the
6 minute mark the Spirodoc will emit an acoustic signal "beep" as a warning, and automatically enter the "walking" stage.
The number of bars (▬ symbol), on the right upper of the screen is proportional to the quality of the oximetry signal: the higher the
quality of the signal the more bars will be shown (maximum 7). Place a finger into the sensor in order to obtain the highest quality signal
possible.
Walking Stage
At the beginning of the "walking" stage the timer is reset to zero so that the user can immediately see of the duration of each single
phase. The data on the display is the same as shown before.
This stage will continue for a minimum of 2 minutes, after which the
stage touch the
icon for a few seconds. If the "walking" stage continues for more than 6 minutes Spirodoc will emit an acoustic
SPIRODOC
icon on the main screen; then select the test with the
cod. 980156
Rev 4.2.1
icon.
icon will appear on screen. Simply touch the
icon appears on screen. To move to the next "recovery"
spirodoc
User manual
EN 40/48
Publicidad
