SKF LINCOLN Centro-Matic P653S Serie Instrucciones De Uso Y Mantenimento página 29

Review of pump
parameters
Display
or
Press
Press the button > 2 seconds.
NOTE
The following display sequence is shown
once. The change of display occurs every two
seconds. Example of pump set to lubricate
each 12 hours 30 minutes and remaining
pause time (rP) is 5 hours 10 minutes.
Display
Pause Time
Display
12 . - (hours)
after one sec.
Display
. 30 - (minutes)
after one sec.
Display
rP - (remaining
pause time)
after one sec.
Display
5 . - (hours)
after one sec.
Display
. 10 - (minutes)
after one sec.
29
Operating mode
Display
NO - Both relay
contacts are
normally open
after one sec.
Display
o2 - Option 2 - How
F1 and F2 will signal
a fault.
after one sec.
Display
SP - Pump starts
with a pause time
after one sec.
Display
Will only appear if
pump has an
internal pressure
transducer.
Maximum pressure
pump will build.
after one sec.
Indicates that
internal pressure
transducer will
close at
3 500 psi (240 bar).
after one sec.