SKF LINCOLN Centro-Matic P653S Serie Instrucciones De Uso Y Mantenimento página 5

Operation,
maintenance and
repair
WARNING

Before carrying out any maintenance or
repair on the P653S pump, make sure that
all lubrication lines of the carrier unit
are depressurized.
Failure to comply may result in death or
serious injury.
Repair
Repair should only be performed by
authorized and instructed personnel
familiar with instructions.
Operation/maintenance
Pumps P653S:
• Must be refilled at regular intervals with
clean lubricant recommended by
manufacturer without air entrapments
under follower plate.
• Operate automatically. Regular check
(approximately every 2 days) should be
made to ensure lubricant is pumped to all
lubrication points.
Disposal
Dispose of used or contaminated lubricants,
as well as of parts in touch with lubricant,
according to legal regulations pertaining to
environmental protection. Make sure to
observe safety data sheets of
lubricants used.
WARNING

Pump P653S must be installed by qualified
personnel. Connection of 120 V AC must be
done according to National Electrical code.
Before installing or working on pump,
disconnect and lock out incoming power.
Failure to comply may result in death or
serious injury.
WARNING

Failure to observe safety instructions,
(e. g. touching electrically charged parts
when pump is opened, or improper handling
of pump P653S) may cause serious injury or
death. If values specified in technical data are
exceeded, device may overheat. It may
damage pump P653S and impair
electric safety.
Failure to comply may result in death or
serious injury.
• Defective printed circuit boards should be
appropriately packed and returned
to factory.
CAUTION

Electric voltage present. In case of pumps
where grease is filled from top, power supply
must be switched off before lubricant is
filled in.
Failure to comply may result in personal
injury or damage to equipment.
CAUTION

Never put your hand into open reservoir
while pump is running. Injury may occur if
pump is being filled from reservoir top.
Failure to comply may result in personal
injury or damage to equipment.
NOTE
Do not exceed maximum filling mark when
filling reservoir by means of pumps with large
delivery volume. Risk of burst if reservoir is
over-filled.
5
CAUTION

Do not use pump in potentially explosive
applications.
Failure to comply may result in personal
injury or damage to equipment.
Installation
• Any safety equipment already installed on
vehicle:
– should not be modified or made
ineffective.
– should only be removed for purpose of
installing system and must be
replaced afterwards.
NOTE
Adhere to:
• installation instructions of vehicle
manufacturer with regard to all drilling and
welding procedures.
• specified minimum distance between holes
and upper/lower rim of frame or between
two holes.
NOTE
Route supply lines professionally. Firmly bolt
together any components subject
to pressure.