SKF LINCOLN Centro-Matic P653S Serie Instrucciones De Uso Y Mantenimento página 36

List of lubricants
NOTE
Absolute cleanliness is essential when
handling lubricants. Impurities will remain
suspended in lubricant and cannot settle.
This will result in damage to lubrication
system and thus to bearing.
Centro-Matic pump can dispense
commercial greases up to NLGI 2 at specified
operating temperature range.
Proven lubricants (see following
tables) have been tested by Lincoln with
regard to pumpability and venting
behavior. Lincoln recommends lubricants for
an application up to indicated minimum
delivery temperature in Centro-Matic
lubrication systems. During tests, lubricants
did not cause any damage due to
incompatibility with material used by
Lincoln.
Proven lubricants
Manufacturer
Caterpillar
Caterpillar
Caterpillar
Fuchs–Lubritech
Fuchs
Fuchs
Fuchs
Fuchs
Fuchs
Mobil
Shell
Shell
Lubricants Lincoln recommends on basis of
manufacturer's data sheet (see following
tables) can be used in Lincoln's lubrication
systems up to indicated minimum delivery
temperature.
Grease pumpability and venting behavior
depend on ambient temperature range of
application, and may be different for same
NLGI grade of grease. This refers in particu-
lar to greases with more than 3% graphite.
Lincoln can test grease and develop
recommendations for specific applications.
NOTE
Consult Lincoln or Lincoln
distributor representative before using
lubricants with solid additives.
Designation Thickener
Moly Ultra 5 NLGI 1 Ca-complex
Arctic Platinum NLGI 0 Ca-complex Synthetic Base Oil
Auto–Lube NLGI 1 Ca-complex
Stabil Eco EP2 Li/Ca
Gleitmo 585 Li
Renocal FN 745 Ca-12-OH-stearat
Renoral FN3 Ca
Renolit LZR 2 t l Li
Renolit HLT 2 Li
Mobilith SHC 100 Li-complex
Retinax EPL 2 Li-12-OH-stearat
Retinax CSZ Li/Ca
Minimum operating temerature
10 °F (–12 °C)
–40 °F (–40 °C)
10 °F (–12 °C)
–13 °F (–25 °C)
–40 °F (–40 °C)
–13 °F (–25 °C)
–4 °F (–20 °C)
–4 °F (–20 °C)
–13 °F (–25 °C)
–13 °F (–25 °C)
14 °F (–10 °C)
–31 °F (–35 °C)
36
NOTE
Manufacturer of centralized lubrication
system can accept no liability for:
• damages due to use of greases that are
not, or only conditionally pumpable in
centralized lubrication systems
• damages on parts of centralized
lubrication system caused by chemical or
biological changes of lubricant used
• damages due to incompatibility with other
materials
Liability is limited to pumpable lubricants in
centralized lubrication systems.