Acknowledge fault
Display
Press
< 2 sec.
< 2 sec.
< 2 sec.
< 2 sec.
< 2 sec.
23
To acknowledge malfunction
• Flashing display changes into
continuous light by pressing button
(acknowledging). By acknowledging fault
signal, flashing E1, E2, E3, E4 or LL
changes into permanent light.
• Messages that have been acknowledged
but not yet remedied will flash again after
pump is switched off and on again.
• After fault has been acknowledged, no
more lube cycles will take place until
successful manual lube cycle has
taken place.