DENTSPLY Multimat 2 Touch Manual De Instrucciones página 46

Each Multimat2 Touch+Press is additionally supplied with:
–1 compression socket
–1 filter control with manometer and compressed air tube
For pressing FAC pressable ceramics, you will furthermore need
3.4.2 Language selection aluminum oxide pistons, embedding
paper and muffle set.
These parts are included in the FAC complete set. Should you
require individual parts, you can order these with the numbers
D430112 FAC large muffle set
FAC small muffle set (not available in Germany)
D430114 FAC aluminum oxide piston
D430115 FAC embedding paper
• Please retain the transport package.
The supplied package protects the instrument from transport
damage. If possible, keep the package material, in case you
need to transport the instrument later.
3.3 Setup
• Place the furnace on a suitable surface and allow for sufficient
distance to walls (min. 25 cm).
• Place the firing socket on the firing socket holder.
• Connect the power plug of the Dentsply vacuum pump
with the vacuum pump socket on the furnace and insert the
vacuum tube in the tube connector on the furnace. The arrow
on the filter must point into the direction of the vacuum pump.
• If you have a Multimat2 Touch+Press, insert the compressed
air tube of the filter pressure control into the Schott plug
connection of the furnace.
• Connect the filter pressure control with the compressed air
feed and set the operating pressure of the pressure furnace
to 2.7 bar (the operating pressure of 2.7 bar is set by the
manufacturer).
3.4 Initial operation
• Before establishing the power connection, check whether the
mains voltage of your power supply corresponds to the mains
voltage specified on the type label of your furnace.
• Connect the power lead with the furnace and with a mains
socket. The green power LED above the numeric sensor pad
illuminates.
3.4.1 Start screen display
The start screen display showing the Dentsply logo, the version
number of the software as well as the serial number of the con-
trol unit will appear on the screen for 6 seconds.
The firing chamber with a possibly vacuum will be filled with air.
The following screen will appear:
46
3.4.2 Language selection
Figure 4: Language selection menu
The language selection will be displayed only after resetting the
language in the main menu (see section 4.5.2.3) and a complete
disconnection from main power.
3.4.3 Introduction
Figure 5: Introduction screen
3.4.4 Installation and safety notes
Figure 6: Installation menu
3.4.5 Functional test
Figure 7: Functional test menu
Select your language
by pressing the
appropriate round,
yellow sensor button.
The sensor button
changes color upon
pressing. There is
no time limit for
language selection.
The language may
also be changed later.
Press the right arrow
to continue to the
next screen.
The most important
installation notes as
well as the note to
follow the installation
and safety notes in
the operating manual
are displayed.
Confirm with the OK
button that you have
complied with the
installation notes and
press the right arrow.
The functional test
starts automatically
and is documented in
the display. The test
result is shown in an
info field. If there are
no errors and all test
sections are ticked
off, the next screen
"Basic settings" is
displayed automatic-
ally after completion
of the test.