DENTSPLY Multimat 2 Touch Manual De Instrucciones página 55

If you wish to save a program under an individual number, use
the numeric keypad to enter a different program number and
confirm with "S". The firing parameters will be saved. By entering
a new number, the old program with this number will be over-
written. You will be asked to confirm the overwriting.
5.7 Start program
1. Open the firing chamber with the button " " on the right
sensor keypad (if not opened yet).
2. Press the sensor button "Start/Stop". The furnace changes
to the screen "Firing curve".
The firing curve illustrates all firing steps. Initially, the firing curve
is empty, and it will be filled with color during the firing sequence.
Below the firing curve the times for the individual firing steps are
displayed, counting down to zero. The displayed remaining time
is the estimated addition of all partial times.
If selected in the basic settings, the printer or PC icon is displayed
on the right edge of the screen.
The following functions can be selected during firing:
Function
a. View
b. Abort view
c. Abort program
d. Abort vacuum/view
e. Change firing parameters
f. Confirm messages
g. Activate Night Mode
Programming the firing parameters is the same in all firing
modes.
5.8 Standard functions
5.8.1 Opening a program
1. Press the sensor button "R" and
2. enter the program number.
3. For program numbers lower than 100, press "R" again.
4. Press the soft key "List" and browse the available programs.
The desired program is directly displayed by pressing the
relevant sensor button.
Activation
Sensor button lift „ ", and „ "
to close again
Sensor button "Start/Stop"
Sensor button "Start/Stop"
Sensor button "C"
Sensor button " "
Sensor button "C"
Sensor button "Night Mode"
5.8.2 Saving a program
Save your program by pressing the button "S". The entered firing
parameters will be checked on validity. Invalid firing parameters
will be shown in the info field and must be corrected after press-
ing the button "C". Once all firing parameters are accepted,
the control system proposes to use the next available program
number as a storage location. Press the button "S" again to
accept the default setting.
If you wish to save a program under an individual number, use
the numeric keypad to enter a different program number and
confirm with "S". The firing parameters will be saved. By entering
a new number, the old program with this number will be over-
written. You will be asked to confirm the overwriting.
5.8.3 Changing a program
Change your program by directly selecting the firing parameter
and entering the new value with the numeric keypad.
The new value will be saved by:
a. selecting the firing parameter again or
b. selecting another firing parameter or
c. saving the program
5.8.4 Changing a program during the firing sequence
All firing sections not yet processed may be changed while firing
is in progress. For this, press the button " " in the firing curve
screen. The firing parameter screen is displayed. The firing pro-
cess can also be observed in this screen.
Select the firing parameter to be changed, enter changed value
and confirm by selecting the parameter again (see section 5.8.3).
The yellow sensor buttons of the processed and running firing
section are masked out and cannot be changed. The change is
one-time, is not saved and is only valid for the currently running
program. Press the button " " to change to the firing curve
screen again. After the firing is complete, the original parameters
are displayed again.
5.8.5 Copying a program
Open the program to be copied, Press the sensor button "S"
and enter a new program number with the numeric keypad,
if required. Press the button "S" again to copy the program.
If the entered program number already exists, a message is
displayed.
Press the sensor button "S" twice to copy the program to the
next free program number.
55