DENTSPLY Multimat 2 Touch Manual De Instrucciones página 66

9.2 Firing table for Finesse metal ceramic (Dentsply Mode)
(Use honeycomb firing material carrier.)
Prog # Program
Description
311 D-FIN-Powder-
Opaque
312 D-FIN-Paste-
Opaque
313 D-FIN-Joint Opaque/ 675
Margin/margin mod.
314 D-FIN-Correction
Opaque
315 D-FIN-1 st Main Firing
Opaque dentine,
Dentine,
Dentine effect,
enamel,
gums
316 D-FIN-2 nd Main Firing 450
Opaque dentine,
Dentine,
Dentine effect,
enamel,
gums
317 D-FIN-Correction
Firing
318 D-FIN-Glaze firing/
Stains
319 D-FAC-repair
porcelain
320 D-FAC-Shade
stain porcelain
D = Dentsply mode
FIN = Finesse Metal ceramic
FAC = Finesse All Ceramic
depending on desired degree of glaze
Caution!
Firing parameters not listed in the firing table must be set to "0" when entering values.
Caution! Do not use pressing socket for firing.
Notes: Make a test firing if required, and adjust firing temperatures or times. For a large number of objects, temperatures or times must
be increased appropriately.
66
Preheat / Drying Preheat
Low Temp. Time
°C min. min.
450 03:00 03:00
450 05:00 03:00
03:00 07:00
450 05:00 03:00
450 05:00 05:00
05:00 05:00
450 05:00 05:00
450 03:00 03:00
450 05:00 05:00
450 03:00 01:00
Vacuum Rate of Firing/
Level Temp. Rise High Temp. Time
hPa °C/min. °C
50 90 800
50 90 790
50 35 770
50 90 760
50 35 760
50 35 750
50 55 730
– 70 750
50 35 810
– 100 730
Vacuum Firing
Time
min. min.
00:30 01:00
00:06 00:30
00:06 00:30
00:06 00:30
00:06 00:30
00:06 00:30
00:06 00:30
– 00:06
00:06 00:30
– 01:00