Publicidad
Overview of Pressure Control Features
Float Valve
The float valve provides a visual indication of pressure within the cooker and
appears in 2 positions.
Pressurised
The float valve has visibly popped
up above the surface of the lid.
The float valve and silicone cap work together to seal in pressurised steam. These
parts must be installed before use and should be cleaned after each use.
DANGER Whilethefloatvalveisup,contentsofcookerare
under extreme pressure. Do not attempt to remove
the lid. All pressure mustbereleased,andfloatvalvemustbe
down. Refer to
Depressurising the Cooker (Venting Methods)
information on releasing pressure. Failure to follow these instructions
may result in property damage and/or personal injury.
Remove the Float Valve from the Lid
Place one finger on the flat top of the float valve, then turn the lid over.
Detach the silicone cap from the bottom side of the float valve.
Remove the float valve from the top of the lid. Do not discard the float valve
or silicone cap.
Top
Illustrations in this document are for reference only and may differ from the actual product.
Always refer to the actual product.
30
Depressurised
The float valve has descended
and the top is flush with the lid.
for
Bottom
Overview of Pressure Control Features
Install the Float Valve
Drop the narrow end of the float valve into the float valve hole on the top of the
lid. Place one finger on the flat top of the float valve, then turn the lid over. Firmly
attach the silicone cap to the bottom of the float valve.
Do not attempt to operate the pressure cooker without the float valve and/or
silicone cap properly installed in the pressure cooking lid.
Condensation Collector
The condensation collector sits at the back of the cooker base and accumulates
overflow moisture from the condensation rim. It should be installed before
cooking, then emptied and rinsed out after each use.
Remove the Condensation Collector
Pull the condensation collector away from the cooker base; do not pull down.
Note the tabs on the cooker base and the grooves on the condensation collector.
Install the Condensation Collector
Align the grooves on the condensation collector over the tabs on the back of the
cooker base and slide the condensation collector into place.
Illustrations in this document are for reference only and may differ from the actual product.
Always refer to the actual product.
31
Publicidad
