Hella Gutmann mega macs PC SE Manual De Instrucciones página 147

Hella Gutmann
4. Select >Update<.
NOTICE
Insufficient voltage supply
System data loss
Do not switch off the PC and the HG-VCI PC during the software update and do not disconnect both from
voltage supply.
Ensure sufficient voltage supply.
5. Start Update with
ð The device searches for a new update that will then be downloaded and installed.
ð The mega macs PC SE software will be finished automatically upon a successful software update. The installation will
be checked automatically after startup.
10.2.6. Calling up HG-VCI PC Information
Here you will find all information required for the identification of the HG-VCI PC.
Proceed as follows to call up the HG-VCI PC information:
1. Select Settings > Update in the main menu.
2. Select the >HG-VCI PC< tab.
ð An info window appears.
ð This menu provides the software and hardware version and the module type of the HG-VCI PC.
10.2.7. HG-VCI Update
NOTICE
Insufficient voltage supply
System data loss
Do not switch off the PC and the HG-VCI PC during the HG-VCI PC update and do not disconnect them from
voltage supply.
Ensure sufficient voltage supply.
Proceed as follows to start the HG-VCI PC update:
1. Select Settings > Update in the main menu.
2. Select the >HG-VCI PC< tab.
mega macs PC SE
.
Configuring the mega macs PC SE | 10.
147