Publicidad
Idiomas disponibles
Idiomas disponibles
10. | Configuring the mega macs PC SE
4. Start BPC-Tool update with
5. Regard the window with information and instructions.
6. Confirm the window with infos and instructions with
ð Update of the BPC-Tool will start. The device searches for a new update that will then be downloaded and in-
stalled.
ð The message BPC-Tool update successful. appears if the update was successful.
10.3.1.4. Calling up System Information for the BPC-Tool
Here you can find all information required for identification of the BPC-Tool.
Proceed as follows to call up system information of the BPC-Tool:
1. Select Settings > Interfaces.
2. Select >BPC<.
3. Push
to call up System information.
ð An info window appears.
ð Here you can find information including the product name, the product ID and the operating system.
10.3.2. Configuring the printer
10.3.2.1. Printing with Standard PC Printer
Here you can set the standard printer for printing with the PC on which the mega macs PC SE software is installed.
For this, the mega macs PC SE software shall forward the data to be printed to the Hella Gutmann Drivers. Then the
Hella Gutmann Drivers send the data to the standard printer of the system.
Proceed as follows to print out results with the standard printer:
1. Select Settings > Interfaces.
2. Select >Printer<.
3. Open a list under Interface with
4. Select >Gutmann Portal<.
ð The selection will be saved automatically.
5. Use
to open the virtual keypad under top (mm). The margins are set ex works to 15 mm.
6. Delete the number set ex works with
7. Enter the requested height of the margins in mm.
8. Confirm your entry with
ð The input will be saved automatically.
9. Repeat steps 5-8 for further entries.
150
.
.
or
where necessary.
.
.
Hella Gutmann
mega macs PC SE
Publicidad
