MAHLE X30 Manual De Usuario página 15

016
•
Through the Duo control unit: You can operate
your X30 system with the Duo control unit. This con-
troller and your e-bike communicate via cable. The
controller is connected to the e-bike system via ca-
ble and consists of two buttons, one at the top and
one at the bottom.
Operation
Short press of top button
Short press of bottom
button
Long press of top button
Long press of bottom
button
NOTICE
The e.Bike manufacturer can set up or change the
functionality of the left and right remote buttons in the
case of electronic shifting, or top and bottom in the case
of the Duo control.
This functionality is set by default during the manufac-
turing process. For more information on this product,
please refer to the manual included in the electronic ex-
changes or download it from the website:
mahle-smartbike.com.
3.2.4. Pedal assistance mode
This mode enables you to get assistance from the engine
when you have to push the bike while walking and with
both hands holding the handlebars. This helps, for exam-
ple, when cycling in areas that are not very cycle-friendly.
To use the walk assist mode (Walk mode), a remote elec-
tronic shifter or an external remote control (Duo) is required
to enable it to function correctly.
To activate the ride assistance, press and hold the right
button on the electronic shifter, but please note that the
bike manufacturer can always customise the functionality
of the electronic shifting.
The maximum speed of the driving assistance is 6 km/h
(approximately 3.5 mph) and if exceeded, the driving assis-
tance will automatically switch off. The driving assistance
will also be switched off when the button is released.
The colour of the current assistance level will be displayed
on 50% of the LED bar, when the walk mode is active.
This animation will be visible as long as the mode is active.
Action
Increase assistance
Decrease assistance
Turn the lights on/off
Activate walk mode
NOTICE
Remember that the driving assistance mode should only
be used when moving on foot, without being mounted
on the bicycle, with both hands holding both sides of
the handlebars and with two wheels in contact with the
ground to avoid injury.
NOTICE
The manufacturer may modify the functionality of the
right and left buttons. Check the manual for your specif-
ic model for detailed information. If you hold the button
down for longer, you can control both the pedal assis-
tance and the lights.
Due to some particular regulations, the original manufac-
turer may configure the e-Bike status lights
when starting up the system.