MAHLE X30 Manual De Usuario página 17

018
Other information displayed by the con-
3.3.4
trol unit
The battery status and the level of assistance are shown by
the colour and length of the LED bar.
Depending on the status of the e-Bike system, additional
information can be transmitted:
The battery status and the level of assistance are shown by
the colour and length of the LED bar.
Depending on the status of the e-Bike system, additional
information can be transmitted:
Turing off the bicycle.
A white animation is displayed after the button has been
held down for a few moments.
Turing on the bicycle.
A white animation is displayed after the button has been
held down for a few moments.
State of charge during charging.
A cyan-coloured animation with flashing effect is displayed.
Battery charged.
Steady green LED bar.
Bluetooth BLE connected or disconnected.
A blue animation is displayed.
Lights on or off.
A yellow exterior animation is displayed when the lights are
switched on.
A yellow exterior animation is displayed when the lights are
switched off.
Error.
A flashing red light is displayed when the system has an
active error. Switch off the system and make sure that the
error has been rectified.
WARNING
A flashing orange light is displayed when the system has
an active warning. The use of the system is not prohibit-
ed, but the warning should be heeded.
Update in progress.
A flashing pink light is displayed when the software update
is performed on the system.
Drive assist mode activated.
The colour of the current assistance level will be displayed
on 50% of the LED bar, when the walk mode is active.
This animation will be visible as long as the mode is active
3.4. Functioning of the active charger
3.4.1. X30 Active charger
The X30 active charger includes a CAN-BUS communi-
cation system. This charger is compatible with all internal
batteries of MAHLE's X30 System and extension leads.
The charger enables fast charging up to 4A, using the CAN
communication port to identify the battery model and cur-
rent charge level, supplying the appropriate charge current
based on the current charge level.
It includes 2 LED bars to inform about charging mode and
status, projecting a backlight against any surface, such as
wall or floor.
As an optional feature, a wall bracket is available to attach
the charger, keeping the wiring organised when not con-
nected to the e-Bike or while charging.
3.4.2. Charging process
To ensure correct charging, follow these instructions:
1. Connect the charger from the power socket.
The LED on the charger will show a steady white light.
2. Connect the charger to the charging port of the
electric bike.
The LED on the charger and the bike control unit will turn
cyan.
Breathing effect: from high to low frequency with increas-
ing charge level.
3. Charging process completed
Once charging is complete, the LED on the control unit will
display a steady green light.
Disconnect the charger from the power supply before dis-
connecting it from the e-Bike.