Yamaha WaveRunner GP1300R Manual De Servicio página 498

HULL
HOOD
1
REMOTE CONTROL CABLES AND
SPEED SENSOR LEAD
SERVICE POINTS
WARNING
When routing the cables, do not grasp the
cable by the outer crimped sheath or steel
end. This could deform or loosen the cable
end due to extreme angles and or pressure.
Always hold the cables by the bracket or
outer cover below the crimp.
If a cable becomes damaged, replace it.
Never attempt to repair a damaged cable.
Remote control cable inspection
1. Check:
• Steering cable
• QSTS cable
Frays/kinks/rough movement →
Replace.
Steering cable installation
1. Install:
• Steering cable (jet pump end)
Steering cable set length a
(jet pump end):
13.5–15.5 mm (0.53–0.61 in)
WARNING
The steering cable must be screwed in a
minimum of 8 mm (0.31 in).
Steering cable stopper installation
1. Install:
• Steering cable stopper
WARNING
Be sure to fit the steering cable into the
groove 1 in the steering cable bracket.
8-17
E