Publicidad
Introductions
EN
This guide describes the steps taken following delivery, from unpacking to first use. To ensure safe
operation, be sure to read these instructions before using the product.
Meaning of Symbols
!
Caution
Cautions must be followed to avoid bodily injury.
c
Important: Important must be followed to avoid damage to this product.
Note: Notes contain useful or additional information on the operation of this product.
Safety Instructions
EN
Read these instructions in their entirety before assembling the product, and be sure to follow the
safety instructions in the User's Guide when using the product.
Assembly
Do not install or store in locations that are unsteady or exposed to vibration from other devices. The product
could drop or tip over, causing injury.
Do not leave in locations exposed to extensive oily smoke or dust or to leaking water or other sources of high
humidity. Failure to observe this precaution could result in fire or electric shock.
The product is heavy and should not be lifted by one person alone. The product should be unpacked and
moved by a minimum of two persons.
Maintain a natural posture when carrying the product. Failure to observe this precaution could result in injury.
When carrying the product, hold it where specified in the manual. Holding the product in other locations could
cause the product to drop or trap your fingers when the product is lowered, causing injury.
If the product is placed on stand with casters or wheels, the casters or wheels should be locked before work
begins to ensure that the product does not move. Injury could result if the product moves unexpectedly during
operation.
Handling Media
Because the media is heavy, it should not be carried by one person. When loading or removing the media, use
at least two persons.
!
Caution
!
Warning
Setup Flow
EN
The workflow for this product differs as follows depending on when it was purchased.
Purchased at the same time as the printer
Referring to both this guide and the printer's Setup Guide, follow the procedure below.
Printer's Setup Guide
Assembly
Stand (1)
Printer Installation (2)
Media Feeding Unit
Auto Take-up Reel Unit
Parallel Adjustment
Initial Ink Charging (5)
Loading Media
Performing a Test Print (7)
Installing the Software (8)
Purchased later
Before installing this product, remove all the standard media units.
c
Be sure to install the two units (Media Feeding Unit/Auto Take-up Reel Unit) together as a
set.
5
SC
EN
This guide
FR
Assembly (3)
TC
Parallel Adjustment (4)
KO
Loading Media (6)
JA
Publicidad
Capítulos
