Autonomous Help Screen - Nilfisk Liberty SC50 Instrucciones De Uso

6/2020

AUTONOMOUS HELP SCREEN

Pressing the Autonomous Help Screen Switch (S) will bring up a help screen of information and/or
actions the operator can take at that particular point in time (screen will vary depending upon what the
machine is currently doing, where it's located and what is allowed). Use the four Navigation Arrows (Y1)
to move through the screen. Use the information switch to make a selection and the left arrow key to exit
the screen. The table below shows actions that can be taken directly from the screen, the table on the
previous page shows informational messages.
Machine State
At machine start up,
autonomy system is booting
up
No location tag scanned nor
stored, machine CANNOT
see a location tag
Location tag scanned.
Machine not located on a
recorded plan
Location tag scanned.
Machine is located within the
start area of a recorded plan.
Location tag scanned.
Machine is located on a
recorded plan but not within
the start area of the plan.
Autonomy module is not
responding
*Tag: 0 . . moving "0" indicates that machine is actively scanning for a location tag.
**Tag: Example "Tag: 227" where "227" is the location tag ID number.
12/2017
Appears on Display
MACHINE READY
For autonomous
cleaning, drive to
location tag
menu, ff scrub on
MACHINE READY
For autonomous
cleaning, drive to
location tag
menu, ff scrub on
MACHINE READY
To play back or
record plan, drive to
start point
$ menu, £ record
AUTONOMOUS CLEANING
Start point found
Press >= to start plan
menu, >= start
MACHINE READY
To play back or
record plan, drive to
start point
$ menu, £ record
MACHINE READY
Autonomy not
responding. Manual
cleaning only.
menu, ff scrub on
INSTRUCTIONS FOR USE
Autonomous Help Screen
AUTONOMY BOOTING UP
Manual mode available
35
¢ exit
NO LOCATION TAG
Set new location tag
¢ exit, $ select
NOT ON PLAN
Record new plan (¨)
Scan location tag
Delete tag #227
¢ exit, $ select
AUTONOMY
Start plan (>=)
Scan location tag
Delete this plan
Delete tag #227
¢ exit, $ select
ON PLAN
Record new plan (£)
Scan location tag
Delete tag #227
¢ exit, $ select
AUTONOMY UNAVAILABLE
Autonomy not responding
Manual mode only
¢ exit
56091204 - Nilfisk Liberty SC50
ENGLISH - A
S
. . . 48
Tag: ...
Tag: 227
Tag: 227
Tag: 227
A - 19