Nilfisk Liberty SC50 Instrucciones De Uso página 42

A - ENGLISH
RECORDING FOR AUTONOMOUS MODE - CONTINUED
WHILE RECORDING IN COPYCAT OR FILL-IN MODES...
Recording needs to be paused
1 If operator is interrupted during the recording process, release foot from Go Pedal to stop machine and step off the machine to stop all
functions. If operator steps off the machine at any time during the record process the machine will stop moving but recording will be paused.
2 Remove the magnetic SmartKey and attend to other issues.
After returning, first replace the SmartKey then step back onto the machine. Press the Forward Arrow (Q) and resume recording.
3
NOTE: If operator steps back onto the machine before replacing the SmartKey, the screen will show No Key Indicator (X19) and exit out of
recording without saving. Plan will need to be re-recorded.
NOTE: Operator must return prior to the machine entering Sleep Mode ("Inactive Time" is adjustable) in order to resume recording.
Recording needs to be canceled
1 If recording process needs to be stopped (to re-fill solution tank, empty recovery tank etc.) release foot from Go Pedal to stop machine
movement and press the Stop Switch (T) to finish recording then press left arrow to cancel.
2 The machine will not remember where it left off recording and plan must be re-recorded. After emptying recovery tank, refilling solution etc.,
return to start point and re-record the plan.
TIPS FOR CHOOSING A START POINT
• Be mindful of where you start a plan so it's not in a busy or congested area, but also in a logical place to start cleaning. Start point should
be in a location that's easy to remember and get to in the future since machine will need to be located there each time to start playback.
Machine will return to the start point at the end of cleaning a Fill-In plan.
• Start position should be near a flat wall when and if possible. It is recommended starting with the right side of the machine next to a wall.
• Record plan with the left side of the machine facing into the room.
• Two plans cannot have the same start point. If two start points are close to each other the machine will playback the plan which has the
start point nearest to the machine. Any two start points should be a minimum of 8 ft. (2.4m) apart. NOTE: Using a second location tag
would allow for two plans to have the same start point.
A - 42
INSTRUCTIONS FOR USE
Nilfisk Liberty SC50 - 56091204
6/2020
12/2017