Nilfisk Liberty SC50 Instrucciones De Uso página 5

6/2020
CAUTIONS AND WARNINGS - CONTINUED
CAUTION!
• This machine is not approved for use on public paths or roads.
•
This machine is not suitable for picking up hazardous dust.
•
Do not use scarifier discs and grinding stones. Use only pads or brushes intended for floor cleaning. Nilfisk will not
be held responsible for any damage to floor surfaces caused by using the wrong or improper pads or brushes.
• When operating this machine, ensure that third parties, particularly children, are not endangered.
•
Before performing any service function, carefully read all instructions pertaining to that service task.
• After use power the machine off at the power switch, do not leave the machine unattended where it can be accessed
by others.
•
Power the machine OFF at the power switch and remove the magnetic SmartKey, before changing the brushes, and
before opening any access panels.
• Take precautions to prevent hair, jewelry, or loose clothing from becoming caught in moving parts.
• When working on the Liberty SC50 and a battery disconnect is needed, ensure that the Autonomy Module is
completely powered off before the power is pulled from the system. To verify that the Autonomy module is completely
powered down simply wait for both the safety LiDAR's and Dropoff lasers to power off, plus an additional 15 seconds
after that. If this procedure is not followed when disconnecting the battery there is a chance that the Autonomy Module
could be permanently damaged, and would need replacement.
•
Use caution when moving this machine in below freezing temperature conditions. Any water in the solution, recovery
or detergent tanks or in the hose lines could freeze, causing damage to valves, pumps and fittings. Flush with low-
temperature windshield washer fluid.
•
The batteries must be removed from the machine before the machine is scrapped. The disposal of the batteries
should be safely done in accordance with your local environmental regulations.
• Do not use on surfaces having a gradient exceeding that marked on the machine.
•
All doors and covers are to be positioned as indicated in the instruction manual before using the machine.
•
This machine should only be used and stored indoors.
• Do not spray this machine with pressurized water.
• The machine's magnetic SmartKey has a built-in magnet. Do not place objects having magnetic bands (such as
credit cards, electronic keys, phone cards) near the key. The built-in magnet can damage or erase the data stored on
the magnetic bands.
• Only use locations designated as "Tie Down Locations" to secure the machine during transport. Using any other
location of the machine to tie down the machine may cause damage or injury.
•
Do not operate the machine in an environment exceeding 104°F (40°C).
• Do not operate the machine without the Bumper (18) in place.
• Avoid driving the machine onto stairways or escalators, into open elevator shafts, or into any area where there is a
significant drop in elevation. Serious machine damage may result if it falls down stairs, escalators, or open shafts.
The machine cannot climb stairs. Machine is designed for use only on flat surfaces (less than 2 degree incline). Place
garbage can or similar object in front of escalators while recording plan to prevent machine entry.
• Do not operate the machine on a grade outside that which is written on the nameplate.
• While driving the machine manually, to develop navigational maps as part of recording the autonomous plans, it is
the Operator's responsibility to avoid contact with obstacles and individuals. The machine will not avoid them in the
manual operating mode. There are no autonomous safety functions operating in the manual mode.
• Do not operate the machine on wet floors.
• Do not operate the machine near other autonomous vehicles.
• Ensure daily and periodic safety checks are completed.
12/2017
INSTRUCTIONS FOR USE
56091204 - Nilfisk Liberty SC50
ENGLISH - A
A - 5