Any fault codes detected by the controllers will be displayed on the control panel display as they occur. If more than one fault exists, the display will sequence

through the fault codes. The fault code will display across the top of the screen.

Fault codes are displayed as follows;

● Fault Code (X1a) will appear in the Display Header (X1)

● Brief description of the error will appear in the center of the screen (some descriptions will have two screens of information that will toggle every four

seconds)

● The Fault Indicator will appear on the right of the screen

● For non-critical faults the operator can exit the fault screen (shown in the Display Footer (X2)), for critical faults the technician can navigate to the menu to

troubleshoot the error.

X1a Active Fault Code

Display Footer

X14 Fault Indicator

X1a

12/2017

FAULT 5-F455

Machine is outside

the permitted

cleaning area

exit

FAULT 5-F455