Stopping The Machine - Nilfisk Liberty SC50 Instrucciones De Uso

A - ENGLISH

STOPPING THE MACHINE

1 CB1 Stop the machine by releasing the CB2 CB3
K1
5A 5A 15A
Go Pedal (24) or rotating the Speed
Adjustment Knob (P) all the way
counter-clockwise while operating in
Manual Mode.
2 In Autonomous Mode machine can be stopped by one of the following methods;
• Stepping onto the Operator Presence Pedal (25), (this will temporarily stop machine, if operator stays on machine for 30 seconds it will exit
autonomous mode)
• Pressing the Stop Switch (T) or the Play/Pause Switch (V)
• A temporary resume area will be created for each of these situations (plan can resume playback from the location machine was stopped).
NOTE: The electromagnetic brake built into the drive wheel is engaged automatically when the Go Pedal is not pressed (or in autonomous
mode when machine stops playback).
3 In the event of an emergency, to stop all machine functions immediately, press the Emergency Stop (D).
• The display will state "Release the red emergency stop button to continue".
• To reset the machine functions, rotate the emergency stop clockwise. NOTE: Machine steering still works with the Emergency Stop
activated.
• A temporary resume area will not be created if Emergency Stop is pressed (plan playback will have to begin at the plan's Start Point).
ACTION REQUIRED
Release the red
emergency stop
button to continue.
A - 36
INSTRUCTIONS FOR USE
Nilfisk Liberty SC50 - 56091204
P
Q
R
D
6/2020
24
25
26
CB1 CB2
K1
5A 5A
T V
12/2017
CB3
15A