Viewing Data While Stopwatch / Lap Is Running - Oregon Scientific Smartheart SE300 Manual De Usuario

To get the most out of your stopwatch functions complete your user
and exercise profile. If you have not completed the user profile you will
be unable to use the calorie and % fat burned function.
• Press MODE to enter CHRONO Mode. You can now perform the
following functions:
TASK
Start stopwatch
Pause / resume
stopwatch
Reset
Save lap
Select exercise
profile for
stopwatch
Turning on / off
auto lap
NOTE The stopwatch begins measurement in min:sec:1/100 sec. After
59 minutes pass, the display will change to hrs:min:sec.

VIEWING DATA WHILE STOPWATCH / LAP IS RUNNING

While the stopwatch or lap functions are being used, press SET to view
and toggle between the following screen displays:
• Total time / split time and current heart rate
• Lap time and current heart rate
INSTRUCTION
Press ST / SP / +.
Press ST / SP / +.
Press and hold SET.
Press LAP / MEM / - while the
stopwatch is running.
NOTE Up to 60 laps or 99 hrs:59 mins
total can be stored in the memory.
1. Press and hold SET.
2. Press ST / SP / + or LAP / MEM
/ - to select 1 of the 3 exercise
profiles. Press SET to confirm.
After selecting exercise profile, the
setting AUTO-LAP on/off will appear.
Press ST / SP / + or LAP / MEM / - to
select. Press SET to confirm.
If AUTO-LAP is on, a lap will be taken
automatically once you have traveled
a pre-set distance (e.g.
NOTE If auto-lap function (by distance)
is selected, stopwatch will be paused if
speed is zero.
26
1.0km).