3M DBI SALA 7241420 Manual Del Usuario página 12

Inspection Date:
Components: Inspection:
System Label and Inspect the System Label and System Certifi cate. Confi rm that system use will comply with all
System Certifi cate of the following criteria:
 The System Certifi cate is valid and system certifi cation is current. The system should be
certifi ed annually or at the intervals specifi ed by the Certifi ed Installer. Do not use the
system if system certifi cation is not current.
 The Maximum Number of Users is not exceeded.
 Correct Personal Protective Equipment (PPE) will be used (including proper Lanyard Length).
 Ground Clearance is still the same as specifi ed on the System Label and there is no risk of
collision in the event of a fall (including Swing Fall hazards).
Traveler Visually inspect the Traveller for damage or wear. Ensure the Traveller closes securely and can
1
not slip off the HLL Wire Rope, Intermediate Brackets, and Corner Brackets.
Energy Absorber Visually inspect the Energy Absorber for signs of previous deployment. The Coils (A) should be
1
(Figure 9) tightly rolled with no tearing of metal between holes.
Visually inspect the Tension Indicator (B) to ensure the HLL is properly tensioned with Shoulder
Washer at the end of the Tension Spring positioned within the Green Zone (√) on the Tension
Label.
HLL Wire Rope Visually inspect the HLL Wire Rope for cuts, kinks (A), broken wires (B), bird-caging (C),
1
(Figure 10) welding splatter, (D) corrosion, chemical contact areas, or severely abraded areas. Wire Rope
must be replaced by the Certifi ed Installer if there are six or more randomly distributed broken
wires in one lay, or three or more broken wires in one strand in one lay. A "lay" of wire rope
is the length of wire rope it takes for a strand (the larger groups of wires) to complete one
revolution or twist along the rope. Replace the wire rope assembly if there are any broken wires
within 25 mm (1 inch) any swaged component.
Brackets and Visually inspect all Brackets and End Anchors for wear or damage. Make sure they are securely
End Anchors attached to the Anchorage Structure.
1
Labels (Figure 11) Verify that all labels are securely attached and are legible.
PPE and Other Additional Personal Protective Equipment (Harness, Lanyard, etc) that used with the 8mm HLL
Equipment Permanent Horizontal Lifeline Fall Arrest/Fall Restraint System should be inspected per the
manufacturer's instructions.
1 — Overhead HLL Systems may be diffi cult to visually inspect without exposure to fall hazards. The Certifi ed Installer may require increased frequency of Periodic
Examinations instead of Pre-Use Visual Inspections. This will be specifi ed on the System Documentation and System Certifi cate.
Serial Number(s):
Model Number:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Corrective Action/Maintenance:
Table 2 – Inspection and Maintenance Log
Inspected By:
(See Section 1 for Inspection Frequency)
Date Purchased:
Date of First Use:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
Approved By:
Date:
User