SURE petcare SureFlap Manual Del Usuario página 23

When using power tools, please follow all safety instructions provided with
the product.
5
6
7
8
9
1
10
4
11
Now it's time to prepare for cutting. We strongly advise that you
drill pilot holes in the corners of the outline to make it easier to
cut the hole with a jigsaw. Make sure these holes are touching
the line and that they are big enough for the blade of the jigsaw
to fit through.
Using a jigsaw, cut around the inner edge of the line you marked.
Once the hole is cut, we recommend you choose the correct length
of screw to attach the Pet Door out of those provided. Do this by
measuring the length of the screw against the depth of your door.
The screw must be roughly 20mm (3/ 4 ") longer than the depth of
your door to hold the Pet Door in place.
Apply a line of clear all-weather sealant to the back of both mounting
adaptors, about 15mm (5/ 8 ") from the edge. Make sure your Pet Door
is nearby and ready to be fitted. Place one of the mounting adaptors
(it doesn't matter which) over the tunnel of the Pet Door so that
the patterned side with the ribs is facing outwards and is not
touching any surfaces.
We advise that there are two people present for this step; one
person inside the house and one outside. From inside the house,
put the tunnel through the hole in the door ensuring it is going
through the centre of the hole and not touching any edges.
Remember the SureFlap logo and LCD display must be inside
the house.
From the outside of the house, check that the tunnel is in the
centre of the hole and then take the second mounting adaptor
and slide it over the tunnel with the sealant facing the door.
You may need the person on the inside of the house to keep
pressure on the Pet Door to make sure it stays in place.
Next, slide the external frame over the tunnel. Using a cross head
3
screwdriver and the length of screw you'd chosen, secure the
external frame in place. Fasten the first screw until it is secure,
but not too tight, then do the same with the remaining three.
2
Once all four screws are secure, tighten them, but make sure
to alternate between screws as you go to ensure the product
is tightened evenly.
Now, insert the four screw caps,
noting that the groove needs to
be facing away from the tunnel.
EN
22