Fitting Your Pet Door In A Wooden Or Plastic Door - SURE petcare SureFlap Manual Del Usuario

Fitting your Pet Door in a wooden
or plastic door
Tools and supplies required
Ruler
Spirit level
Blu Tack
Step-by-step guide
Before you begin, have you programmed in all of your pets? If not, see page 13.
1
X
2
3
X
When using power tools, please follow all safety instructions provided with the
product.
4
17
Sharp pencil
Electric jigsaw
Protective eye-wear
To ensure your pet has unhindered access through the Pet Door,
measure the height of their tummy from the floor. This measurement
is the distance from the floor to the bottom edge of the hole you
need to cut. So, mark this height on your door where you want to
position your Pet Door.
Attach a ball of Blu tack (or similar adhesive putty) to each rear
corner of the external frame so that you can attach it to the door
and use it as a template.
Stick the frame to the door aligning the bottom edge of the hole
with the mark you previously made. Use a spirit level to ensure
the product is straight, then run a sharp pencil around the inside
edge of the frame.
Now that you have a clear outline drawn on the door, it's time to
prepare for cutting. We strongly advise that you drill pilot holes
in the corners of the outline to make it easier to cut the hole with
a jigsaw. Make sure these holes are touching the line and that
they are big enough for the blade of the jigsaw to fit through.
Please feel free to watch
our online installation videos.
surepetcare.com/support/microchip-pet-door-connect
Electric drill with a selection of drill bits
Cross head screwdriver
The screws and screw caps provided