Measures At The End Of Use - Hupfer ITW Manual De Instrucciones

Section 5
Page 22
Regenerate
§
Start the regeneration program by briefly pressing the on/off key (7). Alternatively, wait until the re-
generation process is activated automatically at the programmed time.
The display of the control panel shows the remaining duration of the current phase and the end of the re-
generation process. The end of the regeneration process is displayed on the display and an audible signal.
Unloading
§
At first stop the current regeneration program if necessary.
§
Then pull out the mains plug from the socket and plug it into the holder at the machine.
§
Release the total lock and roll the induction trolley to the destination.
§
At the destination, lock the casters with the total locks.
§
Unlock the doors and remove the trays.
5.4

Measures at the End of Use

ATTENTION
Proceed as follows to switch off the induction trolleyInduction trolley:
§
At first stop the current regeneration program if necessary.
§
Then pull out the mains plug from the socket and plug it into the holder at the machine.
§
Push or pull carefully the induction trolleyInduction trolley (if necessary) to the destination place.
§
Secure the casters with the total locks.
Induction trolley
ITW
Damage to appliances
Mobile induction trolleys may not be touched at the spool carriers or moved
manually. The spool carriers can break easily.
For moving the devices always hold the push bars.
Operation
Measures at the End of Use
91249668_A2