Safety Instructions; Introduction; Warning Symbols Used; Safety Instructions For Appliance Safety - Hupfer ITW Manual De Instrucciones

Safety Instructions

Introduction

2 Safety Instructions
2.1 Introduction
The section on safety instructions describes the risks associated with the appliance in terms of product lia-
bility (according to the EU Directive).
The safety instructions should warn of hazards and help to avoid damages to persons, the environment
and property. Please make sure that you have read and understood all the safety instructions given in this
section.
You must comply with the respectively valid national and international Safety at Work Regulations. The
manufacturer is responsible for the valid regulations he/she has to provide. He/she must acquaint him-
self/herself and the operator with the new regulations.
In addition to these operating instructions, comply with the Health and Safety rules of the German Federa-
tion of the Statutory Accident Insurance Institutions for the Industrial Sector, especially with those that con-
cern the handling of hot items and risks involved (BGR 110 "Protection of health and safety at work in res-
taurants" and BGR 111 "Protection of health and safety at work in large-scale kitchens").
2.2

Warning Symbols Used

Symbols are used in these operating instructions to indicate the dangers that may occur while operating or
cleaning the appliance. In both cases, the symbol provides information on the type and circumstances of
hazards.
The following symbols may be used:
2.3

Safety Instructions for Appliance Safety

The appliance is operated safely if it is used correctly and carefully. Negligent handling of the appliance can
lead to a threat to life and physical well-being for the user and / or third parties as well as hazards for the
appliance itself and the operator's other property.
The following points are to be observed to ensure the appliance safety:
§
The induction trolley may be installed and connected only by trained operating staff.
§
The appliance may only be operated as intended, when it is in perfect condition with regards to
technical standards, with awareness of safety and hazards and in accordance with the operating in-
structions.
§
All operating and actuating elements must be in a perfect and fail-safe condition with regards to
technical standards.
§
Before putting the appliance into operation, the appliance must be checked for external visible dam-
age and defects. In case of damage, inform immediately the competent bodies and switch off the
induction trolleyInduction trolley.
§
Modifications or retrofits to the equipment are only permitted after consultation with the manufactur-
er and upon receipt of their consent in writing.
§
Never use the connecting lead to pull the mains plug out of the socket.
§
Never pull the mains plug out of the socket during a current regeneration process, warming phase
or cooling mode.
§
If the mains plug has come into contact with water, it must be dried before inserting it into the sock-
et. Danger to life.
91249668_A2
General hazard area
Hazardous electrical voltage
Section 2
Page 9
Induction trolley
ITW