Safety Instructions For Transport; Safety Instructions For Cleaning And Care; Safety Instructions Regarding Fault Repair - Hupfer ITW Manual De Instrucciones

Section 2
Page 10
§
Damaged mains plugs or connecting leads are to be replaced by authorised personnel before the
appliance is used again.
§
Do not use extension leads in wet and damp areas.
§
The induction trolleys can start moving on their own and randomly if the casters are not locked with
the total locks.
§
Before transporting, switch off the induction trolley, pull out the mains plug and insert it into the
holder provided.
§
Release the total locks before moving it. Moving the appliance when the total locks are engaged can
damage the chassis!
§
Do not move the appliance over inclined surfaces or stairs. When approaching walls and moving
round obstacles, always pay attention to persons or obstacles in the way.
§
During traction operation it is not allowed to move the induction trolley faster than a walking pace. It
is difficult to brake and steer heavily laden appliances.
§
When moving the induction trolleys make sure that the appliance will not tip over due to outside in-
fluences or inattention. If, nevertheless, it tips over never try to catch the induction trolley.
§
Do not stop the appliance on sloping floors. Before placing the appliance in position make sure that
the floors are level and even and the induction trolleys are level.
§
Secure the induction trolley against rolling away by applying the total locks before putting it into op-
eration.
2.4

Safety Instructions for Transport

The following points are to be observed when transporting the induction trolleyInduction trolley:
§
When loading, use only hoists and load lifting devices approved for the weight of the appliance to be
lifted.
§
Only use transport vehicles that are approved to carry the weight of the induction trolley.
§
Do not put a defective appliance into operation under any circumstances and inform the supplier
immediately in such a case.
2.5

Safety Instructions for Cleaning and Care

The following aspects must be taken into account when performing any cleaning and care tasks:
§
Take the induction trolleyInduction trolley out of operation, switch it off, pull out the mains plug and
secure against unauthorised reactivation before performing cleaning and care measures.
§
Observe applicable hygiene regulations and guidelines.
§
Cleaning instructions must be strictly observed for reasons of hygiene.
§
Induction trolleys are only optionally suitable for washing devices. For technical clarification always
consult
2.6

Safety Instructions regarding Fault Repair

The following aspects must be taken into account when carrying out any fault repairs:
§
The local Accident Prevention Regulations in force must be observed.
§
Take the induction trolleyInduction trolley out of operation, switch it off, pull out the mains plug and
secure against unauthorised reactivation before performing maintaining or troubleshooting opera-
tions. The appliance must be switched off at the mains and secured against reactivation when work-
ing on the electrical system. This work must only be carried out by a qualified electrician.
§
Observe the valid product safety regulations for the product when handling oils, greases and other
chemical substances.
Induction trolley
ITW
®
HUPFER before the appliance is cleaned in a washing device.
Safety Instructions
Safety Instructions for Transport
91249668_A2