Adjust Springs - Hupfer OTA/47–36 Manual De Instrucciones

Chapter 5
Page 26
NOTE
Put on the cover of the spring case.
Put the frontal sheet into the embedded folding of the sheet.
Insert the screws and tighten the cover of the spring case.
Adjust the position of the spring case
The spring case can be adjusted continuously up to 8.66'' (220 mm) to the front.
Figure 15
Remove the screws (1) and pull out the frontal sheet with plastic stop beads.
Carefully loosen both plastic stop beads (3) in the base plate with a knife or a screwdriver and set it
aside. Later they need to be shortened according to the new position of the case spring.
Loosen the four nuts (2) that connect the spring case with the base plate, but do not remove them
completely. Therefore use an open-end wrench SW 17.
Pull the spring case until the desired position is reached.
Screw the nuts back into place.
Shorten the plastic stop beads (3) at the blunt ends and insert into the grooves in the base plate.
Put the frontal sheet into the folding of the sheet on the the ground and fix it with screws (1) on the
spring case.
5.2.3

Adjust springs

Since the tray dispensers are designed for a maximum load, the available spring system of the appliances is
entirely sufficient for all purposes.
Before loading, the crockery dispensing height must be adjusted to the trays used. The dispensing height is
adjusted by hooking or unhooking tension springs. So long as the same kind of trays is always used, the dis-
pensing height only needs to be set once.
When using open tray dispensers, it is permitted to stack over up to 1.97'' (50 mm). This maximum protru-
sion of the tray dispenser above the upper edge of the spring case may not be exceeded.
Tray dispenser
OTA/47–36 | OTA/53–37 | OTA/58-33 | OTA/53–37 S | OTA/U-BW | OTA-E/BA-4xGN | TAG-1/53-37 | TA-2/53-37 | EBS-T/53-37
Uniform rotation
Pay attention to uniform rotations, as the chassis of the stacking platform can
get twisted.
Adjust the spring case
Operation
Adjustment of the open tray dispensers
4330041_A0