Getting Started; Unpacking The Watch; Batteries - Oregon Scientific SMARTHEART Instrucciones De Instalación Y Manual De Usuario

GETTING STARTED

UNPACKING THE WATCH

When you unpack your SmartHeart SE190 Heart Rate
Monitor, make sure to keep all the packing materials
in a safe place, in case you need to later transport or
return the product for servicing.
In this box, you will fi nd:
• Heart rate monitor watch
• Chest belt
• 2 x CR2032 lithium batteries
NOTE Do not dispose this product as unsorted
municipal waste. Collection of such waste separately
for special treatment is necessary.

BATTERIES

The unit uses a CR2032 lithium battery for the receiver
watch and a CR2032 for the heart rate chest belt. Both
are included with the units. When the battery of the
receiver watch is running low,
To replace the watch battery:
SE190_M_EN_R3
will light up.
4
1. Turn the watch over so that
you are looking at the back
plate.
2. Disconnect the watchstrap as
shown.
3. Using a small screwdriver
remove
that hold the back plate into
position.
4. Remove the back plate and set
it aside.
5. Using a thin blunt instrument,
hook the release catch and loft
the clip.
6. Remove the old battery.
7. Slide the new battery into the
compartment with the + side
upwards.
8. Replace the battery clip.
9. Replace the back plate and
screws.
4
2006.4.24, 3:22 PM
the four screws