Uline OHAUS RANGER 7000 Manual Del Usuario página 12

Set the Average Piece Weight (APW)
NOTE: It is recommended that the APW is larger
than 1d. If APW is between 0.05d and 1d,
a warning screen will be displayed and the
information line will show "Low APW". If APW is
less than 0.05d an error screen will appear and
the APW value cannot be stored.
There are three ways to set the APW. (See page 8)
Defining Over/Under Limits
Press the button corresponding to the
enter Limit Setup.
NOTE: See page 11 for information on how to
set the Over/Under limits.
Application Setup
The Application can be customized for various user
preferences. Press the button corresponding to the
icon to enter Configuration Setup. (See Figure 26)
Figure 26
The Configuration Menu is now displayed. Select
the list item and press the button corresponding to
to change the setting as desired. To return
to the Application home screen, press the button
corresponding to
Figure 27
PAGE 12 OF 105
OPERATION CONTINUED
icon to
. (See Figure 27)
Check configurations are defined below (defaults in bold).
ITEM AVAILABLE SETTINGS
Check Check Weighing,
Mode Check Counting
Audible Off, Under, Accept,
Signal Over, Under & Over
Auto Opt* On, Off
APW Auto
On, Off
Save*
Opt. Beep* On, Off
Auto Tare On, Off, On Accept
Chain Tare On, Off
Off, Automatic,
Accumulate
Manual, On Accept
Graph
Bar, Block
Display
* Only available in check counting mode.
Positive Check
Positive check is used to determine when the material
added to the scale is within the target range. In this
case the Under and Over Limits must be positive values.
(The Over Limit must be greater than or equal to the
Under Limit.)
Negative Check
Negative check is used to determine when the material
removed from the scale is within the target range. In
this case the Under and Over Limits are both negative
values.
The Under Limit must be greater than or equal to the
Over Limit (for example: Under = -10/Over = -15).
Place item to be weighed on the scale and press Tare.
Remove a portion of the item until it is within the
Accept range.
FUNCTION
To set mode
To enable Beeper Signal
To enable Automatic
Optimization of APW
To enable APW Automatic
save
To enable Optimization
Beep
To enable Automatic Tare
"On Accept" means that if
the object weight is within
accept range, Auto Tare
will be performed
To enable Chain
(Continuous) Tare
To enable Accumulation/
Totalization
"On Accept" means that
if the object weight is
within accept range,
auto Accumulate will be
performed.
To set Graph Display Type
0721 IH-7991