Uline OHAUS RANGER 7000 Manual Del Usuario página 5

CHANGE UNIT OF MEASURE
SET UNIT OF MEASURE AT STARTUP
Enter this submenu to customize scale display functionality.
SCALE SETUP SUBMENU
Reset
Language
Power On Unit
Power On Zero
POWER ON UNIT
Set the unit that will be displayed at Power On:
Auto
Kilogram
Pound
Gram
ENABLE UNITS OF MEASURE
WEIGHING UNITS
Enter this submenu to activate desired units of measure.
NOTE: Due to national laws, the scale may not
include some of the measurements listed.
UNITS SUBMENU
Reset
Kilogram
Pound
Gram
NOTE: The setting is locked when the security
switch is set to the locked position.
PAGE 5 OF 105
OPERATION CONTINUED
Key Beep
Expand Display
Barcode
Rule
Ounce
Pound: Ounce
Custom Unit
Ounce
Pound: Ounce
Custom Unit
CUSTOM UNIT
Use the Custom Unit to display weight in an alternative
unit of measure. The custom unit is defined using a
conversion factor, where the conversion factor is the
number of custom units per gram expressed in scientific
notation (Factor x 10^Exponent).
FACTOR
Set the conversion factor using the numeric keypad.
Settings of 0.1000000 to 1.9999999 are available.
The default setting is 1.0000000.
EXPONENT
Set the factor multiplier.
-3 = divide the factor by 1000 (1x10
-2 = divide the factor by 100 (1x10
-1 = divide the factor by 10 (1x10
0 = multiply the factor by 1 (1x10
1 = multiply the factor by 10 (1x10
2 = multiply the factor by 100 (1x10
LEAST SIGNIFICANT DIGIT
Set the graduation.
Settings of 0.5, 1, 2, 5, 10, 100 are available.
The Custom Unit's name can be customized up to
3 characters.
NOTE: Custom Unit is locked at Off position
when security switch is set to locked position.
RESET
To reset the unit settings to factory default settings select
RESET and then confirm either Yes or No.
TURNING A WEIGHING UNIT ON/OFF
Select desired unit, then press the button corresponding
to the icon, then choose On or Off. (See Figure 7)
The current menu item status is shown.
OFF = disabled
Figure 7
)
-3
)
-2
)
-1
)
0
)
1
)
2
ON = enabled
0721 IH-7991