Uline OHAUS RANGER 7000 Manual Del Usuario página 16

Application Setup
The Application can be customized for various user
preferences. Press the button corresponding to the
icon to enter Configuration. (See Figure 39)
Figure 39
The Configuration Menu is now displayed. Select the list
item and press the button corresponding to
change the setting as desired. (See Figure 40)
Figure 40
To return to the Application home screen, press the
button corresponding to
The Formulation Configurations are defined below
(defaults in bold).
ITEM AVAILABLE SETTINGS
Formulation
Free, Recipe
Mode
Compensation At the End, Off,
Mode Immediately
Input/Output (I/O) Setup
The I/O's can be customized for various user preferences.
The I/O's are defined below (defaults in bold).
ITEM
Discrete Input 1 Off, Zero Tare, Clear Tare, Quit, Next item, Last Item
Discrete Input 2 Off, Zero Tare, Clear Tare, Quit, Next item, Last Item
Discrete Output 1 Off, Overload, Underload
Discrete Output 2 Off, Overload, Underload
Discrete Output 3 Off, Overload, Underload
Discrete Output 4 Off, Overload, Underload
PAGE 16 OF 105
OPERATION CONTINUED
, to
.
COMMENTS
To Set Mode
To Set Compensation
Mode
AVAILABLE SETTINGS
NOTE: The I/O's will only work when the I/O
Option Board has been installed. The I/O option
board provides two isolated inputs and four
dry-contact normally open relay outputs which
can be used for simple process weighing.
Press the button to enter the Main Menu. With the
button corresponding to the
list and highlight Application Mode. Enter this submenu
by pressing the button corresponding to the
(See Figure 41)
Figure 41
In the Application Mode menu enter the Formulation
submenu. (See Figure 42)
Figure 42
The Formulation submenu is now displayed. Select the list
item and press the button corresponding to the
icon to change the setting as desired. (See FIgure 43)
Figure 43
icon, go down the
icon.
0721 IH-7991