Uline OHAUS RANGER 7000 Manual Del Usuario página 14

NOTE: Press the
explanation.
1. Press the button corresponding to the
enter the Enter Component screen. (See Figure 31)
Figure 31
2. Select the list item and press the button
corresponding to the
value as desired using the alphanumeric keypad.
The item name and target weight are required to be
entered. Press the button corresponding to the
icon to confirm all the values and continue with the
formulation. (See Figure 32)
Figure 32
NOTE: The
all the required values have been entered
(item name and target weight).
NOTE: The entered target weight will be used
as preset tare.
3. Place the required weight on the pan (add weight
until the displayed value reaches zero again).
4. When weight matches the tolerance range of the
target weight, the display digits will be highlighted.
When the displayed value reaches zero, the scale
will beep once.
PAGE 14 OF 105
OPERATION CONTINUED
button for button icon
i
icon, to change the
icon will only appear when
5. Press the button corresponding to the
confirm the weight for the current component and to
continue adding other components. (See Figure 33)
icon to
Figure 33
NOTE: To terminate the formulation process,
press the button corresponding to the
icon. If the added weight is over the tolerance
limit, compensation will be performed
according to the setup in the configuration
(At the end, Off, Immediately).
NOTE: When the compensation is active (at the
end or immediately), if the component added
is within tolerance the capacity bar is always in
green color.
NOTE: If one component added is outside the
tolerance, the scale will do compensation for
next items. In this case, the value displayed
is not actual weight and the capacity bar will
turn red.
To finish the formulation – press the button
corresponding to the
component. Then the formulation will finish and a
Formulation Result screen is displayed. (See Figure 34)
Figure 34
To print the formulation result – press the button
corresponding to the
To save the formulation result – press the button
corresponding to the
To return to the main screen – press the button
corresponding to the
icon to
icon and add the last
icon or the button.
icon.
icon.
0721 IH-7991