Dynamic Weighing - Uline OHAUS RANGER 7000 Manual Del Usuario

The Filling Configurations are defined below (defaults
in bold).
ITEM AVAILABLE SETTINGS
Auto Tare On, Off
Chain Tare On, Off
Accumulate Off, Manual
Input/Output (I/O) Setup
The I/O's can be customized for various user preferences.
The I/O's are defined below (defaults in bold).
ITEM
Discrete Input 1 Off, Zero, Tare, Clear Tare, Print, Start/Stop
Discrete Input 2 Off, Zero,Tare, Clear Tare, Print, Start/Stop
Discrete Output 1 Off, SP1, SP2, Target, Alarm
Discrete Output 2 Off, SP1, SP2, Target, Alarm
Discrete Output 3 Off, SP1, SP2, Target, Alarm
Discrete Output 4 Off, SP1, SP2, Target, Alarm
NOTE: The output will be reset to normally open
when both SP1 and SP2 are reached. The I/O's
will only work when the I/O Option Board have
been installed. The I/O option board provides
two isolated inputs and four dry-contact
normally open relay outputs which can be
used for simple process weighing.
The outputs also only work when the button
corresponding to the
Press the button to enter the Main Menu.
(See Figure 53)
Figure 53
With the button corresponding to the
down the list and highlight Application Mode. Enter this
submenu by pressing the button corresponding to the
icon.
PAGE 19 OF 105
OPERATION CONTINUED
COMMENTS
To enable Automatic Tare
To enable Chain
(Continuous) Tare
To enter Accumulation/
Totalization
AVAILABLE SETTINGS
icon has been pressed.
icon, go
In the Application Mode menu enter the Filling submenu.
(See Figure 54)
Figure 54
The Filling submenu is now displayed. Select the list item
and press the button corresponding to the
change the setting as desired. (See Figure 55)
Figure 55

DYNAMIC WEIGHING

Use this application to weigh an unstable load, such
as a moving animal. Three different start/reset modes
can be selected: Manual (start and stop via key press),
Semi-Automatic (auto-start with manual reset), and
Automatic (start and stop automatically).
Press the button until Dynamic is displayed in the
upper left portion of the home screen. (See Figure 56)
Figure 56
Press the button corresponding to the
averaging. To abort the averaging press the button
corresponding to the
When the averaging has finished, press the button
corresponding to the
icon to
icon to start
icon.
icon to reset.
0721 IH-7991