Uline OHAUS RANGER 7000 Manual Del Usuario página 8

NOTE: The I/O's will only work when the I/O Option Board
has been installed.
The I/O option board provides two isolated inputs and
four dry-contact normally open relay outputs which can
be used for simple process weighing.
Press the button to enter the Main Menu.
With the button corresponding to the
the list and highlight Application Mode. Enter this submenu
by pressing the button corresponding to the
In the Application Mode menu enter the Weighing
submenu. (See Figures 12-13)
Figure 12
Figure 13
The Weighing submenu is now displayed. (See Figure 14)
Select the list item and press the button corresponding
to the icon to change the setting as desired.
Figure 14
PAGE 8 OF 105
OPERATION CONTINUED
Use this application to count samples of uniform weight.
1.
2. Setup APW value (see below) and then place objects
icon, go down
icon.
THE COUNTING HOME SCREEN
Set the Average Piece Weight (APW)
There are three ways to set the APW:
A. Positive Sampling
1.
2. Alternatively, press the button corresponding to the
3. Key in the desired number of pieces using the
The display returns to the home screen. (See Figure 15)
Figure 15
COUNTING
Press the button until Counting is displayed in
the upper left corner of the home screen. The default
(or last) Average Piece Weight (APW) is displayed.
on the pan to display the number of pieces.
NOTE: Press the
i
explanation.
NOTE: It is recommended that the APW is larger
than 1d. If APW is between 0.05d and 1d, a warning
screen appears. The information line will show
"Low APW". If APW is less than 0.05d an error screen
will appear and the APW value cannot be stored.
Place sample on pan, then key in number of pieces
using the alphanumeric keypad and press the
button corresponding to the
icon. A numeric input screen will appear.
alphanumeric keypad, and then press the button
corresponding to the
Main Display Line
Reference Fields
Functions
button for button icon
icon to confirm.
icon.
0721 IH-7991