Uline OHAUS RANGER 7000 Manual Del Usuario página 27

Sieve Weighing – Sieves in a set can be entered as a
mix of inch, # and mm or cm sizes, but the Ranger 7000
uses mm measurements for all of its calculations.
Each individual Sieve can be edited so that the following
information is associated with the Sieve. (See Figure 88)
Figure 88
Unit – The Sieve gradation in inches, #, cm or mm.
Value – The numeric value for the unit (ex.: a "3" for a 3
inch sieve).
Calculate FM – The individual Sieve will be used to
calculate the Modulus of Fineness.
Display Value – How the individual Sieve will be shown
on the Sieve Set summary in the Library.
Value (mm) – The conversion of the Value and Unit for
the Sieve into mm.
Once all Sieves in at least one Sieve Set have been
added to the Library under Sieve Weighing, the Sieve
Weighing Mode can be used.
RETRIEVING A LIBRARY RECORD
1. To load a Library record from the home screen press
the button. The Weighing Library screen is now
displayed. (See Figure 89)
Figure 89
2. Use numeric keypad to search the library. For
example, keying in 111 will lead you to the library
ID:111 (If exists).
3. Press the button corresponding to the
load the library data and return to the application
mode related to the library record.
NOTE: Scanning a barcode twice will retrieve
the library record directly.
PAGE 27 OF 105
OPERATION CONTINUED
EDITING A STORED LIBRARY RECORD
To delete a stored record, follow "Retrieving a Library
Record" (See previous).
1.
2. Then press the button corresponding to the
The Edit Library Item screen will be displayed.
(See Figure 90)
Figure 90
3. Make the necessary changes and press the button
DELETING A STORED LIBRARY RECORD
To delete a stored record, follow "Editing a Stored Library
Record" above.
1.
Figure 91
2. Press the button corresponding to the
icon to
Use the buttons corresponding to the
icons and to move up and down in the list
and highlight the Library item to be edited.
icon.
corresponding to the
library List.
Press the button corresponding to the
A new screen will be displayed asking for
confirmation. (See Figure 91)
delete the record, or press the button corresponding
to the icon to go back to the previous screen.
and
icon to return to the
icon.
icon to
0721 IH-7991