The Conveyor Module 2 - Festo MPS 400 Serie Instrucciones De Utilizacion

9.3 The conveyor module 2

The motor controller used permits clockwise/counterclockwise rotation, inching operation and speed
control.
The presence of workpieces at the start of the conveyor and at the end of the conveyor is verified by optical
proximity sensors with fiber-optic cables.
• Danger of entanglement!
There is a danger of entanglement in the area of the ball return of the conveyor!
Never reach into this area while in operation!
• Switch off the power supply!
–
–
© Festo Didactic 8122168
Switch off both the operating power and the control power before working on
the circuit.
Only reach into the setup when it is at a complete standstill!
The conveyor module can be mounted on a profile
plate, a profile foot or a slotted mounting plate.
The Conveyor module is suitable for transporting,
buffering and separating workpieces with a diameter
of 40 mm (e. g. workpiece set "Cylinder bodies" or
"For cylinder assembly").
The conveyor belt is driven by a freely positionable DC
gear motor.
WARNING
Joining station – Operating instructions
27