Publicidad
Idiomas disponibles
Idiomas disponibles
(*)
At the following conditions: condenser inlet air temperature 35°C; cooled water temperature 7°C; temperature differential at the evaporator 5
K; fouling factor equal to 0.35x10
(**)
In the following conditions: Chilled water outlet temperature 7°C; temperature differential at the main heat exchanger (evaporator) 5 K; hot
water outlet temperature at the secondary heat exchanger (recovery unit) 45°C at the nominal rate.
(***)
At the following conditions: evaporator inlet air temperature 7°C B.S., 6°C B.U.; hot water temperature 45°C; condenser temperature differential
5 K; fouling factor equal to 0.35x10-4 m2 K/W.
(****)
Sound pressure level in dB(A) referring to a 10 m distance from the unit, in free field and directionality factor equal to Q=2. The noise data refers
to the units without the electric pump
(*****)
Sound power level in dB(A) on the basis of measurements taken in accordance with UNI EN-ISO 9614 and Eurovent 8/1 Standards. The noise
data refers to the units without the electric pump
(■)
Absorbed current/absorbed power value without electric pump
(±)
Recovery unit heating capacity Conditions referring to the unit operating with chilled water temperature 7°C, differential temperature due to
evaporation of 5 K, hot water temperature produced equivalent to 40/45°C (DS). N.B. Operating in winter mode with DC active, the heating
capacity available is decreased from the portion supplied to the desuperheater.
The peak current refers to the unit's most heavy duty operating conditions.
(°)
Data calculated in accordance with EN 14511 under nominal conditions
SEER: Seasonal energy efficiency: low temperature cooling (EU Regulation 2016/2281)
SCOP: Seasonal energy efficiency: low temperature heating in Average climate (EU Regulation No. 811/2013 and N. 813/2013)
The refrigerant charge values are indicative. Refer to the serial number plate
154
EQPI3X
m
K/W.
-4
2
Publicidad
